|
 QTR-2000M
Price: $670.00
The QTR-2000M receiver is built for the serious dog hunter. It contains the
latest state-of-the-art integrated circuitry for maximum sensitivity and noise
suppression. It offers clear, audible chirping signals with 30 percent more
speaker volume than most receivers. In addition, the signal strength meter
responds to the slightest signal impulse for fast, accurate tracking. The meter
will also test the amount of battery life remaining.
The QTR-2000M is powered by an easily replaceable 9-volt battery for a cost of
less than $5.00, and the battery will operate approximately four to six months
under normal use.
The QTR-2000M is lightweight and portable. Most people prefer it mounted on the
antenna for quick and easy access to tracking. It is also vehicle compatible
with a roof-mount antenna and works well from within a vehicle.
The QTR-2000M has a three position range selector switch found only on QTR-2000M
receivers. No other receiver on the market has this feature. This allows the
receiver to track close, medium, or long range, allowing a determination of
approximate distance to your hound. The Close setting will track up to 1/4 mile,
Medium up to 1 mile, and Long Range gives maximum signal reception.
The QTR-2000 now has a new feature. It now has an internal "super amp" built
into the main circuit board. This new feature will allow you gain anywhere from
1/2 - 1 mile more on your range when using this system.
Hunters have performed numerous field tests with the QTR-2000M and determined
that this receiver, when paired with our QT collars, normally tracks out to a
distance of five to ten miles in the long range position (determined by
terrain). This receiver will allow you to track up to 200 hounds.
The QTR-2000M may be set up to track any two of the following frequencies: 216,
217, 218, 219, 220, or 221. The receiver is covered for defects in manufacturing
for a period of three full years.
Pick two Frequencies for the QTR-2000M Unit:
|
|
